• Catalog
• FAQ

5 Knuckle FBB Half Surface Hinge Templates

5 Knuckle FBB Half Surface Hinges - Standard Weight

Available Models and Materials (Standard Weight)

FBB173 (ANSI A8412) – Steel – polished and plated or phosphated and prime coated for painting FBB112 (ANSI A2412) – Brass or bronze – highly polished and painted or plated FBB112 (32) (ANSI A5412) – Stainless steel – highly polished FBB112 (32D) (ANSI A5412) – Stainless steel – satin finish

Templates (Standard Weight)

Templates are arranged in order by size, smallest to largest.

5 Knuckle FBB Half Surface Hinges - Heavy Weight

Available Models and Materials (Heavy Weight)

FBB163 (ANSI A8411) – Steel – polished and plated or phosphated and prime coated for painting FBB113 (ANSI A2411) – Brass or bronze – polished and plated or painted FBB113 (32) (ANSI A5411) – Stainless steel – highly polished FBB113 (32D) (ANSI A5411) – Stainless steel – satin finish

Templates (Heavy Weight)

Templates are arranged in order by size, smallest to largest.

Maintenance – 5 Knuckle FBB Half Surface Hinges

• Keep hinge surfaces clean.

• Clean using a soft, damp cloth only.

• Do not use chemicals that could damage the protective lacquer coating.

• As required, apply Shell Darina #2, or an equivalent grease, to the non-load-bearing center hinge knuckle and pin.

• Bearings do not require lubrication, as they contain polytetrafluoroethylene (PTFE).

Lubrication Procedure

1. Remove the hinge pins.

2. Wipe or dip the pins in grease.

3. Reinsert the pins; the grease will work into the load-bearing surfaces.

4. Wipe away any excess grease and dirt from the hinge.

* Lubrication applies to hinge pins only; bearings are self-lubricating.