• Catalog
• FAQ

5 Knuckle CB Full Mortise Hinge Templates

5 Knuckle CB Full Mortise Hinges - Standard Weight

Available Models and Materials (Standard Weight):

CB179 – (ANSI A8112) Steel – polished and plated or phosphated and prime coated for painting CB191 – (ANSI A2112) Brass or bronze – polished and plated or painted CB191 (32) – (ANSI A5112) Stainless steel – highly polished CB191 (32D) – (ANSI A5112) Stainless steel – satin finish

Templates (Standard Weight)

Templates are arranged in order by size, smallest to largest.

5 Knuckle CB Full Mortise Hinges - Heavy Weight

Available Models and Materials (Heavy Weight):

CB168 – (ANSI A8111) Steel – polished and plated or phosphated and prime coated for painting CB199 – (ANSI A2111) Brass or bronze – polished and plated or painted CB199 (32) – (ANSI A5111) Stainless steel – highly polished CB199 (32D) – (ANSI A5111) Stainless steel – satin finish

Templates (Heavy Weight)

Templates are arranged in order by size, smallest to largest.

* Only available in steel.

Maintenance – 5 Knuckle CB Full Mortise Hinges

• Keep hinge surfaces clean.

• Clean using a soft, damp cloth only.

• Do not use chemicals that could damage the protective lacquer coating.

• As required, apply Shell Darina #2, or an equivalent grease, to the non-load-bearing center hinge knuckle and pin.

• Bearings do not require lubrication, as they contain polytetrafluoroethylene (PTFE).

Lubrication Procedure

1. Remove the hinge pins.

2. Wipe or dip the pins in grease.

3. Reinsert the pins; the grease will work into the load-bearing surfaces.

4. Wipe away any excess grease and dirt from the hinge.

* Lubrication applies to hinge pins only; bearings are self-lubricating.