|
Answer Remove the reader bezel from the trim, it is held in by 4 screws located behind the electronics board. Once the reader bezel is removed, you will locate the read head (it has 2 red and 1 black wires attached to it). Once located, you will need to remove the read head carrier from the bezel by pulling the read head away from the slot where a card would be swiped (be careful not to let the removable rods fall out of the carrier as your are removing it). Once it has been carefully removed, ensure the green box on the read head is lined up with the correct track number you wish to use (1, 2, or 3) |
|
Applies To BEST Offline, V& G, or WiQ WDC |
|
Additional Information |
