Switch™ Core Information & LED Patterns

Switch™ Core Information 

• 3 Modes Supported: Locked, Credential + PIN, Credential Only
• Can hold about 50,000 credentials
• Can store up to 3200 Audits
• Supports up to 30 Holidays, 30 Intervals, and 30 Blacklisted Credentials
• Shipped ready to slide into the SFIC slot
• Sends and receives audits through App
• LEDs
  –Blue – searching for Bluetooth
  –Green – Access Granted / Core Control Mode Engaged
  –Red – Access Denied / Core Control Mode Disengaged
  –Amber – Error
  –Purple – Install Mode
• Replaces the Small Format Mechanical Core
• Uses Mobile Credential or FOB
• Uses Bluetooth
• Has undergone Stress Test/ Impact Test (Think Hammer) Vertical/Side Impact
• Exceeds Grade 1 Standards
• The battery is a Panasonic CR2477
• 1/16th Hex Key Used for Control Lug (Clutch)
• Cap charges when first installed

Battery Information:

• At 2.3V, view status reports 22%
• At 2.2V, view status reports 12%
• At 2.1V, view status reports 01% - Core will not operate at this level
  *The core will cease to grant access at 5% battery 

Switch™ Core LED Patterns

Quadrants	Pattern	Red	Blue	Green	Purple	Example	Descriptions
1-4	Fading on and off for 1 second, every 10 seconds						The Supercapacitor is charging. May last up to 3 minutes.
1&3, 2&4	Alternating at 1-second intervals						Searching and connecting to switch-enabled devices. May last for 1, 3, or 5 seconds depending on the current configuration.  Blue - Standard operating mode Purple - Install Mode Red - Door mode is Locked
1&3, 2&4	Alternating at 0.5-second intervals						Connected to a Switch Enabled device, and processing access or administrative commands. Duration lasts until all commands/access has been processed successfully Blue - Standard operating mode Purple - Install Mode Red - Door mode is Locked
1-4	Fading on and off every 1 second						Access has been granted and continues through the specified operate-time.
1-4	1 rapid blink						Green: Engages/Unlocks the core. Applies to the following use cases: Changing from an Initialized or Configured state to a Factory state Control Mode - Engage Red: Disengages/Locks the core. Applies to the following use cases: Completion of User/Admin Access Changing from a Factory to an Initialized or Configured state Control Mode - Disengage
1-4	2 rapid blinks						Access Denied or Error
1 – 4	Rotating Counter Clockwise						Firmware Update